• If this is your first visit to the iboats.com Boating Forums, be sure to check out the FAQ. To post a question or comment, begin by signing up. To start viewing messages, select the forum that you want to visit from the selection below.
  • **** The forums will be undergoing maintenance tonight approximately 10pm-midnight MDT. Thank you for your patience during this time. ****

Announcement

Announcement Module
Collapse

Help Tip: If you have a question that has not been answered to your satisfaction in the archives, it is always best to start a new thread of your own. By starting your own thread, you will receive the maximum number of views by forum members.

Below are some additional forum policies in hopes of all iboats members will follow, Thank you.

1. Please do not reply to old threads or hijack existing threads. Old threads of a technical nature are like a library book, Please do not write in them.

2. Old threads should be considered archives and used for reference only. Please do not reply to them.

3. Do not take over someone else’s thread (aka hijack) with your own question, even if it is similar. If you have a question that has not been covered to your satisfaction in the archives, it is always best to start a new thread of your own.

4. If you have a question for the original poster (OP) and the thread is over 30 days old, send the OP a PM, he may not even visit the forums any longer, or may not notice your question in the old thread.

5. By starting your own thread, you will receive the maximum number of views by forum helpers that may not even notice your question when it’s posted at the end of someone else’s thread. And those answers will be specific to your particular issue.

6. Please do not post to threads that have been inactive for more than 3 months unless you are the original poster. We have very active forums and any thread that remains inactive for that long should be considered "dead". It is especially confusing when there is an entirely new question posted to an old thread.

7. Posting at the end of any thread is considered to be hijacking the original posters thread which in turn subjects the thread to be closed if it continues to happen thus not making it fair to the original poster in the future had for some reason he/she needed to return for additional information or provide an update of the problem solved which is always welcomed within a reasonable amount of time frame.

8. Please note that you should see a red banner pop up near the bottom of each inactive thread asking you not to reply to old threads. The Red banner will read: Please note this thread has been inactive for 90 days. For the best results, please start a new thread.

Thank you all in advance for doing your part in helping iboats run a smooth ship.

Additional forum rules linked below.
http://forums.iboats.com/forum-rules-guidelines-405/
See more
See less

service bulletin 91-35 understanding

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts


  • service bulletin 91-35 understanding

    1998 merc 150. 2 litre 2 stroke

    in the middle of my rebuild, and saw in a mercury manual that you need to "Remove idle stabilizer/advance module, install idle stabilizer and reset timing.
    Refer to Service Bulletin 91-35." what is this module that needs to be removed and what does it exactly need to be replaced with?


  • #2
    Re: service bulletin 91-35 understanding

    If your engine has one, it retards/advances timing by changing resistance to bias circuit in powerpack. That bulletin tells you to remove to combo module and use only the idle module. This has been updated several times and best advice is to remove it completely and set timing at 22° which will be 20° running. The Xr2/Xr4/Xr6 and 200 hp only have these as the standard 150 usually just had a idle stabilizer.....
    When in doubt,Trim it out!!!
    Business Owner & Certifed Technician
    Boats I own & use
    20ft Javlin w/250 Junkrude
    17ft Bullet w/200 Merc (SOLD!!)
    13ft Allison w/150 I-6
    17ft Hydra-Sport 175GT
    15ft Allison w/75 Stinger(project)
    14 x 48 Drifter with 1100SS Merc

    Comment

    Working...
    X