I have a '91 or '92 Mercury V-6 175 HP 2.5 litre. Serial #OD223009. Yesterday, the tilt stuck in the full down position. Tilt motor runs, and fluid is leaking, but I'm not yet sure where it's leaking from.
I need to get the boat out of the water today to investigate. With it stuck full down, I'm concerned about ground clearance for the skeg of the lower unit while the boat is on the trailer.
Is there a way to manually tilt this bruiser up, and keep it there, enough to get some more ground clearance?
Any suggestions on how to start troubleshooting this condition?
THANKS
P51D
I need to get the boat out of the water today to investigate. With it stuck full down, I'm concerned about ground clearance for the skeg of the lower unit while the boat is on the trailer.
Is there a way to manually tilt this bruiser up, and keep it there, enough to get some more ground clearance?
Any suggestions on how to start troubleshooting this condition?
THANKS
P51D