500dollar744ti
Senior Chief Petty Officer
- Joined
- Jul 23, 2012
- Messages
- 691
The shift foot at the lower unit will not stay up in place where it mates to the upper unit. I'll put it back up into its slot with a pair of pliers (it is sliding up and down) and it will stay for a little while but fall out of place shortly after. I put a small clamp on it and it has stayed in place and worked ever since. I'm trying to figure out if there's a spacer or sleeve or washer missing somewhere that might be causing this so I can fix it next time I split the drive.
Any advice or experience with this would be helpful.
Any advice or experience with this would be helpful.