Should I replace the shift cable when doing bellows on my Alpha One gen II?

[MikeDobbs]

Hi everyone,

I'm getting ready to replace all the transom stuff on my Alpha One gen II outdrive. All 3 bellows, water hose, and bearing (if needed). Should I be replacing the shift cable while I'm in there? It's a 1998 boat, new to me, so I can't say when if ever the cable was replaced prior.

Thanks : )

 

[dozerII]

For the cost of the new cable it would make sense to do it while you have the leg off doing the bellows, and it will eliminate the chance of a shift problem a little while down the road.

 

[flipbro]

Absolutely

 

[MikeDobbs]

For the cost of the new cable it would make sense to do it while you have the leg off doing the bellows, and it will eliminate the chance of a shift problem a little while down the road.

OK- what is a "leg"? Does that refer to the outdrive?

 

[achris]

'Leg' is slang for the complete drive. As for the shift cable, check its condition, if it's in good nick, leave it alone...