Speedenbull
Recruit
- Joined
- Jan 25, 2015
- Messages
- 4
I have a 1975 merc 888 i/o. Where the bellows mounts to the transom by the gamble bearing is ate or should say mostly gone.I have a good plate but would like to use a 76-83 if it will bolt up . Just to get away from spline steering pin . Been looking all over and can not find anything on it though.I know if I go to new with the hole works my motor mounts and ex will not line up.
What I need to find out is if I can just change every thing on the outside of the boat to 76 to 83.I know I need ring and gimble housing and transom plate.But will it bolt up to the inside part.
What I need to find out is if I can just change every thing on the outside of the boat to 76 to 83.I know I need ring and gimble housing and transom plate.But will it bolt up to the inside part.