Speakrdude
Ensign
- Joined
- Feb 25, 2004
- Messages
- 942
Is there a spec for this shim or replace with what was there?
I have the tools for the Driven gears shim and Drive gears
shims, but not the cap.
Also, when calculating the shims for the lower bearing (in the upper half), And the fact that its a press fit bearing race, how do you "pre" Calculate the shim amount so you don't have to knock out the race repeatedly and start over?
I have the tools for the Driven gears shim and Drive gears
shims, but not the cap.
Also, when calculating the shims for the lower bearing (in the upper half), And the fact that its a press fit bearing race, how do you "pre" Calculate the shim amount so you don't have to knock out the race repeatedly and start over?