Watermann
Starmada Splash of the Year 2014
- Joined
- Jan 12, 2013
- Messages
- 13,753
I'm not a MC guru like some here but it sounds like with you had to replace one or both motor mount beds before dropping in the new engine correct? So now the coupler is way out of alignment with the gimbal bearing. If that's the case, I've been there and done that with a re-power job myself. If you have the engine in and the rear motor mounts set then like Alldodge said start trying to align with the bar and make the adjustments with the front motor mounts. I'm assuming you've studied up on that procedure.