Can anyone tell me what this is and its proper orientation?

BeeEl

Seaman
Joined
Jul 25, 2013
Messages
53
image.jpg
It fell out when I removed the drive. I know the seal goes inside the bell housing, but what about the metal piece? This is on a gen II alpha one 3.0LX. The book doesn't show it. I was just gonna glue the seal in but I can't figure out where the metal piece goes. Thanks in advance.
BL
 

thumpar

Admiral
Joined
Jun 21, 2007
Messages
6,138
Re: Can anyone tell me what this is and its proper orientation?

The black ring is the seal that goes in just before the drive. It should be part of the seal kit for re-installing the drive. The metal ring is what Fun Times said.
 

BeeEl

Seaman
Joined
Jul 25, 2013
Messages
53
Re: Can anyone tell me what this is and its proper orientation?

Thank you both so much. I never thought to look there since it literally fell out when I pulled the drive. I got it cleaned up and drove it down in there. Finally got drive re installed. Now to give it a whirl before it gets too cold. Thank you again.
I love this place!
 
Top