998cc
Petty Officer 2nd Class
- Joined
- Mar 30, 2013
- Messages
- 159
All. I have the SELOC manual and have followed it. So far getting the new drive bellows on has been elusive. The Drive, Exhaust and Shift bellows are installed on the gimbal side OK; the bell housing side has been a bear. Drive Bellows: What happens is when pulling the bellows over the hub, the large clamp pops off and sits ahead of the bellows on the hub itself. If I tighten the clamp slightly to keep it on the bellows, it is too tight to slide it over the hub. After multiple attempts, I have run out of the adhesive and have ordered another tube.
Is there a step I am missing here? Are there any tutorials or videos that might help?
Thanks (again)
998cc
Is there a step I am missing here? Are there any tutorials or videos that might help?
Thanks (again)
998cc