Trim and tilt issues

cwoody297

Cadet
Joined
Nov 7, 2011
Messages
6
I am having trouble with my power trim on a 1990 4.3 mercruiser. I have the unit with the yellow cap for the reservoir, seems to be a pretty common unit. I cant get it to do anything, so I took the small motor off and it will run when connected to the negative and either the green or blue cable hooked to positive. I seem to have a problem with this partphoto.JPG

I have 12vdc on the middle screws but nothing on either the right or left screw, this is where the blue and green lines go. Any opinions on this and what is this part and where can I buy one?? Thanks
 

dubs283

Vice Admiral
Joined
Jul 27, 2005
Messages
5,092
Re: Trim and tilt issues

those are the solenoids

one controls the up (blue) the other down (green)

you need to verify that the switch at the control/dash works properly and you are getting voltage to the primary (smaller) posts on the solenoids - that is how they activate and get voltage to the larger posts (right and left side you refer to in your pic)
 

cwoody297

Cadet
Joined
Nov 7, 2011
Messages
6
Re: Trim and tilt issues

Thanks for your reply. I have voltage on the smaller posts you refer to. Does this mean these solenoids are bad?? How can I test them??
 
Top