Just a couple of simple questions.
I am in the process of rebuilding an old Glassply with the Mercruiser 165 Straight 6. I aquired this boat already dissasembled by various people over the last 20 years. It came with 5 Junk engines so not sure which sn actually belongs with the boat and can not find a sn on the outdrive but am pretty sure it is a MC-1
Completely rebuilt the engine and am installing it today so my first question is what holds the front engine mount to the floor?
Also while the engine was out I drove out the gimbal bearing. It had the large snap ring which people have said is no longer needed, but it also had a plastic collar and a couple of brass shims in there also. I have not read anyone discuss these. Are they outdated and not needed with a new gimbal bearing?
Thanks Rob
I am in the process of rebuilding an old Glassply with the Mercruiser 165 Straight 6. I aquired this boat already dissasembled by various people over the last 20 years. It came with 5 Junk engines so not sure which sn actually belongs with the boat and can not find a sn on the outdrive but am pretty sure it is a MC-1
Completely rebuilt the engine and am installing it today so my first question is what holds the front engine mount to the floor?
Also while the engine was out I drove out the gimbal bearing. It had the large snap ring which people have said is no longer needed, but it also had a plastic collar and a couple of brass shims in there also. I have not read anyone discuss these. Are they outdated and not needed with a new gimbal bearing?
Thanks Rob