Hoping someone can help with my power trim problem. Before I describe the problem, here is the info on my boat:<br /><br />2003 Bayliner 175 (I/O)<br />3.0 Mercruiser Alpha<br /><br />When I got the boat uncovered after the winter, I lowered the sterndrive (via the power trim) and started the motor in my yard. When I was done, I raised the sterndrive and thought all was set. I got the boat in the water and lowered the drive and started the motor. After getting it off the trailer, I tried to raise the sterndrive coming into shore, but it would not go up. I finnally got it raised a little more than 1/2 way, but that is the last time it has moved. After reading messages on this board, I have tried a few things without any luck.<br /><br />Fluid level is full.<br />I am getting 12.2V to the power trim motor.<br />The fuse is good.<br />I get 12.2V from the solenoid when the trim switch is pressed.<br /><br />When I disconnect and reconnect the motor from the battery, I will get one, and only one click from the motor the first time I try to raise or lower the sterndrive. Anyone have any suggestions? I would hate to think that a one year old trim motor is already dead, but I am fearing it.<br /><br />Thanks,<br />AD