I have a 1976 Mercruiser 165 L6 with the Pre-Alpha drive.
I bought a used trim cylinder setup with stainless steel lines and when I hooked it up one of the fittings on the boat side was leaking pretty bad. The problem is I can't get any of the fittings off. The wrench just starts slipping. Any suggestions on how to get them off?
I bought a used trim cylinder setup with stainless steel lines and when I hooked it up one of the fittings on the boat side was leaking pretty bad. The problem is I can't get any of the fittings off. The wrench just starts slipping. Any suggestions on how to get them off?