electronic ignition kit from e-spark

[eugene dix]

hello my name is Eugene and I com from Holland.

a have a question.
I have a invader v177 whit a 3.0 mercruiser 130HP.
I botch a electronic ignition kit from www.e-spark.eu
the 3DEL4U1 and the ignition coil ES33HEC
I have read a lot about this.
one ting a am not sure what to do.
I must disconnect the resistance wires from the coil. and make a new wire.
Howe can a find de resistance wire?
but wear do i connect this new wire to, from coil to ?????

thank

 

[alldodge]

Howdy

I am assuming you have points and are changing over to electronic.
The resistance wire is the purple wire which was connected to the + side of the coil. The wire looks like any other purple wire. Remove and tap up the end of the wire

Your carb should have a purple wire on it and it is not resistive. Connect another wire to the choke wire and run it to the + side of the coil

 

[eugene dix]

oke thanks now its clear to my.

​what kind of wire must it by. 1mm? 1.5mm? ore 2mm?

 

[Scott06]

Check what size is there but I think 14 gauge or 1.5 mm will be good

 

[alldodge]

oke thanks now its clear to my.

​what kind of wire must it by. 1mm? 1.5mm? ore 2mm?

Use same size that is on it now

 

[eugene dix]

oke thanks.
I will do it tomorrow.
I will let you now how a don it.

 

[eugene dix]

i have don it. it runs mutts better now at idle

 

[harleyman1975]

Great News! Welcome to I-boats!