FreeBeeTony
Captain
- Joined
- May 15, 2002
- Messages
- 3,991
I know the adjustment is 6" between the center of the barrel to the center of the hole at the tip when fully pressed in (fwd. gear).
After I made the adjustment and looked at the shift slide it appeared to be sticking out too much. I left it for now.
Question: does this adjustment need to be made w/ the drive installed?
After I made the adjustment and looked at the shift slide it appeared to be sticking out too much. I left it for now.
Question: does this adjustment need to be made w/ the drive installed?