dropbear68
Petty Officer 2nd Class
- Joined
- Jan 21, 2013
- Messages
- 199
I have stripped my power tilt down to rebuild / clean out the creamy sludge, silly me didnt bother to take note of where things went, my questions are, down in the resevoir section which i have removed of the motor, undid the 4 bottom screws, lot sof sludge, un did the 4 bolts holding the plate with the 2 springs, out fall bearing/s and a detent with a point, there are 2 springs one long one short, i dont know what goes where, was there one lil bearing or 2, anyone done this before, I cant find a decent picture showing detail, Im very stuck lol
Last edited: