rhcavender
Recruit
- Joined
- Jun 17, 2014
- Messages
- 4
I have a 73 9.5 Evinrude that has new points and condenser, new coils and carb work on it. I was told that the magnets in the flywheel wouldn't hold a bolt. I still runs rough and misses even after all the work. I have been told conflicting things concerning the flywheel. One fellow I know has worked on motors for over 40 years and told me that he has never seen a flywheel go bad, however, even after replacing all these parts with new ones it still does not run right. Any suggestions?
Last edited: