1992 Ebbtide Dyna-Trak 160 SS power tilt and trim

[TonyRoberts]

I have an issue with with the power tilt and trim, the trim works with the switch located on the engine, but the one in the bow and the one on the shifter do not work. any suggestions? by the way, thanks to those who answered the question about the location of the fuse, I found it and replace it.

Thanks,
Tony

 

[fuzzeywiggler]

Re: 1992 Ebbtide Dyna-Trak 160 SS power tilt and trim

put a meter on the switches that dont work, check for power. that is the first thing I would check for.

 

[TonyRoberts]

Re: 1992 Ebbtide Dyna-Trak 160 SS power tilt and trim

Neither switch is getting power, but I cannot find the fuse.

thanks,
Tony

 

[fuzzeywiggler]

Re: 1992 Ebbtide Dyna-Trak 160 SS power tilt and trim

chase the wire possibly inline, you could have a broken wire. run your hand the whole way down the wire feel for and knicks or kinks

If that gets you no-where put your meter on the working switch, under load. then run some new wire either off your fuse block(if you have a spare) or run an inline. just remember where you put the fuse eh! :lol:

 

[TonyRoberts]

Re: 1992 Ebbtide Dyna-Trak 160 SS power tilt and trim

Is there anything I could have done when changing the ignition switch, they worked until I changed the ignition switch?

Thanks,
Tony