Barracuda Bill
Seaman Apprentice
- Joined
- Feb 7, 2010
- Messages
- 40
I am considering rebuilding the lower unit on a 1987 Johnson 15 hp short shaft tiller. It appears a seal is bad (haven't identified the actual cause) and was ran with no lube and LU is very stiff. I am thinking of replacing the bearings and seals, I think the gears are ok, but haven't inspected them yet. I have not consulted a manual yet. Just wondering what I would be getting myself into. Are the bearings pressed in? What degree of difficulty would this project be? Any info from those who know would be appreciated.