icedimensions
Cadet
- Joined
- Jun 25, 2013
- Messages
- 26
I am trying to find out how to reinstall the ball bearing/spring assembly for the shift lever in the remote control assembly.
I have a 1977 Invader Aquarius bowrider with the V6 150. Was removing from boat to remove cap and bearing fell out. Cannot figure out how to get it back in place. I have the schematic, but that only show me where it goes.
Any suggestions?
I have a 1977 Invader Aquarius bowrider with the V6 150. Was removing from boat to remove cap and bearing fell out. Cannot figure out how to get it back in place. I have the schematic, but that only show me where it goes.
Any suggestions?