I have a Johnson 115 HP motor that is equipped with tilt/trim, but it does not work. The motor was checked out and found to be non-functional. I don't know why and I really am not too concerned with it, because we are going to take it off the bass boat it is on and put it on a pontoon, where we will not need the tilt/trim feature. But my question is this: For now, til we decide to swap boats, we want to use it on the bass boat, but the pressure from the pumps I guess will not allow the motor to go down all the way so that the prop is positioned where it needs to be. We tried draining the fluid out of the cylinder on the right side, and lots of fluid came out, but the hydraulic plungers???? (don't know that that is the correct name for them) won't go in anymore to allow the motor to go down any further. Is there anything I can do to release the pressure on those. I just need the motor to go down just one or two more notches.