200 150 hp evinrude ficht computer and oil pump issue

[Allwaters]

Hi i was just wondering if it would be possible to pre mix the fuel on my motor?. It is in need of a new computer but i figure it is not worth it. The engine runs when the harness for the oil pump is disconnected but immediatly blows the fuse when it is reconnected.

 

[Haffiman]

Re: 200 150 hp evinrude ficht computer and oil pump issue

NOOOO! Ficht's need the oiling from the injector!!!!

 

[Allwaters]

Re: 200 150 hp evinrude ficht computer and oil pump issue

Alright well there goes that plan...thanks for the quick reply! i was wondering if it would be possible to run seperate power to the pump while leaving it disconnected from the computer or is there some sort of regulating going on by the computer? I am a carpenter by trade so bear with me..

 

[Haffiman]

Re: 200 150 hp evinrude ficht computer and oil pump issue

It injects oil into the air intakes calculated by the computer depending on throttle setting(TPS), rpm. Without it operating, no oil to crank shaft and bearings.

 

[seahorse5]

Re: 200 150 hp evinrude ficht computer and oil pump issue

which fuse blows? there are 8 of them, one 20 amp and seven 10 amp

What is the resistance of the oil injector windings?

 

[boobie]

Re: 200 150 hp evinrude ficht computer and oil pump issue

Try DFI Industries.com. They repair the EMM's.