i have a 25r71s with elec start. it was a romote that i have made a tiller. i have installed a start switch and will be installing a kill. For now i want to do a compression
test. can i ( for now ) take the two igintion leads at the connecor and wire them together ( to kill the spark ) Also for the kill, same question and what kind of switch should i use as in opened or closed. Where can i get one. below is my WEAK attempt of the connector as you look at the front of the motor
as always any help is welcome
mcmike
o choke here and center below.......this should be lower in the pic....but hey
igintion -->0 o 0 <--- igintion
O O power and ground
test. can i ( for now ) take the two igintion leads at the connecor and wire them together ( to kill the spark ) Also for the kill, same question and what kind of switch should i use as in opened or closed. Where can i get one. below is my WEAK attempt of the connector as you look at the front of the motor
as always any help is welcome
mcmike
o choke here and center below.......this should be lower in the pic....but hey
igintion -->0 o 0 <--- igintion
O O power and ground