Snake Mountain
Recruit
- Joined
- Jun 25, 2011
- Messages
- 5
Engine cover molding & rubber mount needed for 56 30 HP Evinrude Mod 25924 S/N 07237
I have completed restoring this engine. As the photos show, the last two parts I need are the two strips of rubber (?) molding (gasket) that run between the engine cover and engine.
I am also missing one of the rubber mounts for the cover - see photo.
Does anyone have or know where I can source these parts?
Thanks!
I have completed restoring this engine. As the photos show, the last two parts I need are the two strips of rubber (?) molding (gasket) that run between the engine cover and engine.
I am also missing one of the rubber mounts for the cover - see photo.
Does anyone have or know where I can source these parts?
Thanks!