150hp V6 1993 Johnson remote control wires confuse me

[twish29]

Hello expert out there, need some advise, I've factory remote control side mount box with my seaswirl 2101, there are 3 + 2 wires coming out from the box,
the 3 (blue/white, red/white & green/white) done ,
found 2 other wires (both yellow/red) which confused me, don't remember where these 2 wires connect to, if I'm not mistaken 1 of the wire directly to starter wire at ignition switch when I cut 2 months ago for boat rebuilt (which I think not make sense at all) , please help

 

[jonesg]

Re: 150hp V6 1993 Johnson remote control wires confuse me

Your post is incoherrent.

 

[cr2k]

Re: 150hp V6 1993 Johnson remote control wires confuse me

I believe these are the neutral safety switch wires.

 

[boobie]

Re: 150hp V6 1993 Johnson remote control wires confuse me

One yellow/red wire from the control box goes to the S terminal on the ignition switch and the other one has to end up on a small terminal on your starter solenoid.

 

[twish29]

Re: 150hp V6 1993 Johnson remote control wires confuse me

boobie thanks
Done it but why the engine wudn't start/silence, unless I reconnect back the starter solenoid wire (red/yellow) with one of the wire to S terminal and let the other wire hanging without any connection.
At this situation makes my tilt wudn't work anymore . Is this problem due to ground wire??