lazersnake
Seaman
- Joined
- Jul 22, 2010
- Messages
- 54
Hi Guys,
I'm all wired up and ready to install my NOS Faria tach. Looks great, thank you to Sixmark for the help.
I'm running a 15.5' tri hull with a 1982 70 HP Evinrude. The combo runs great. Planes fast and I can back it off quite a bit from WOT to conserve fuel.
Assuming the tach install goes fine, I'm expecting WOT RPM to be around 5000 - 5500.
Being able to back off throttle quite a bit and still plane nicely - how low is too low RPM criusing range? Where, RPM-wise, does this motor run best?
Thx
I'm all wired up and ready to install my NOS Faria tach. Looks great, thank you to Sixmark for the help.
I'm running a 15.5' tri hull with a 1982 70 HP Evinrude. The combo runs great. Planes fast and I can back it off quite a bit from WOT to conserve fuel.
Assuming the tach install goes fine, I'm expecting WOT RPM to be around 5000 - 5500.
Being able to back off throttle quite a bit and still plane nicely - how low is too low RPM criusing range? Where, RPM-wise, does this motor run best?
Thx