I had my block bored, it's 20 over. New pistons, wrist pins, rings, bearings, thermostats. Right now powerhead is together except intake (not mounted yet). I have some new boyseen reeds I would like to use, but I am wondering if I should go to a bigger jetting to avoid any lean pops that could damage the reeds. As of right now my carbs have these 3 jets in them (stock jetting):
#34, #26, #56c
Which should I change? And what Size Should I go to?
Any And all suggestions are welcome and appreciated.
#34, #26, #56c
Which should I change? And what Size Should I go to?
Any And all suggestions are welcome and appreciated.