CaneCutter79
Chief Petty Officer
- Joined
- May 24, 2009
- Messages
- 454
I have a 1979 Evinrude V4 85hp outboard. I think I know how to add power trim fluid to the reservoir but I want to do it right.
Do I simply remove the screw, add the fluid into the reservoir/shaft until the fluid starts to come out? Then replace the cap, tilt the motor up and down a full cycle 3-4 times and that's it?
Do I simply remove the screw, add the fluid into the reservoir/shaft until the fluid starts to come out? Then replace the cap, tilt the motor up and down a full cycle 3-4 times and that's it?