Charge Coil & Sensor Coil Output ?

[R H Cotton]

I have a 1996 88hp Evinrude. I am using a Fluke multimeter with a CDI peak reading adapter. The Clymer repair manual says I should get 150 volts or more when the charge coil is checked. I am getting 346 volts. Is this okay? The output of the sensor coil is supposed to be .5 volts on each pin or more as the manual states. I am getting approximately 2 volts on each pin. Is this okay? How much can "or more" be? All help will be appreciated.

 

[R.Johnson]

Re: Charge Coil & Sensor Coil Output ?

Your reading's are correct on both components