jimbobcooter
Petty Officer 3rd Class
- Joined
- Feb 27, 2012
- Messages
- 78
Hello I am doing my first water pump replacement on my 94 evinrude 120hp etlerc. I am using an evinrude replacement parts and I noticed that the impeller plate is missing s deep grove/stamp in the side closes to the shift rod. Is this ok? Is it a change in design or did I get an incorrect part? Should I worry? Everything else matches up nicely.
Replacement part: Water pump kits, P/N 5001595, 5007972. Pic included: old plate is closest to camera and new plate is sitting on the lower unit.
Also had a o-ring left over but I assume that is due to my 1/2in water tube instead of the 5/8 water tube. Is that correct?
Replacement part: Water pump kits, P/N 5001595, 5007972. Pic included: old plate is closest to camera and new plate is sitting on the lower unit.
Also had a o-ring left over but I assume that is due to my 1/2in water tube instead of the 5/8 water tube. Is that correct?
Attachments
Last edited: