Impeller housing

[mobley]

I took my 1977 115hp evinrude apart to replace the impeller haven't done in sense I got it and the housing looks a lil rough. Is it still useable looks almost like it was heated up. The old impeller wasn't bad was just replacing it cause it's been awhile.
Thanks
Brian

 

[interalian]

Hard to tell. Did you wipe it out before the picture? If so, not too good. If not, wipe and show us again?

 

[oldboat1]

looks like a salt water motor -- in any case, need a new housing and seal (need the whole kit this time).

 

[mobley]

Nope never been in salt water land locked in Iowa. I took the two metal pieces out and they cleaned up good. Found a website that sells the new housing for $29.00

 

[oldboat1]

sounds good. price too. (nope, not heaven .... Iowa.)

 

[abuelo_draco]

Hi, i have a few question about this engine (Jhonson 115ETL77S)
1. Its a 4 stroke right, so does not need mix fuel oil?
2. Where is the shift rod screw, i see a lot of potos but i cant finded, even near of the 2 carburator
Thanks

 

[racerone]

????-----Hold on here , this motor is a 2 stroke and you have to mix gas and oil !!!----Get the owners manual and read it before you turn the key !

 

[GA_Boater]

Old and closed.