Replacing 3 wire Tilt-Trim Selonoid with 2 wire Solenoid

[tannerpace]

Hello my tilt trim will not go up all the time. I have to tap the solenoid while holding down the switch to get it to function. I ordered two new solenoids. They are supposed to be compatible with my motor and all 2002 and ealier m 90a. However these solenoids have only 2 terminals to attach to my solenoid had 4 but only 3 where being used, my question Is how do I wire a two wire solenoid to replace a three wire solenoid? Can this be done? Is it advisable? I have my factory service Manuel.

 

[pvanv]

Did you order/receive two

3C7725901M

SOLENOID SWITCH, PTT

 

[tannerpace]

i got el-35372-5800m tohatsu nissan trim relay oem 3c7-72590-1 & 35372-5800m 60 70 90 120 140

 

[tannerpace]

so yes same number only two terminals, my old relay had 4 terminals, three of them were wired. and two hard wired leads. My replacement is different.Has only two terminals and two hard wired leads.

 

[pvanv]

You apparently got an aftermarket "one size fits all" item. Check with your dealer, as no one else knows for sure. I would recommend the actual part from Tohatsu, since it is still available.

 

[tannerpace]

The dealer i ordered from is going to take it back, apparently i got wrong part, go figure it was only 10 bucks, could you send me an invoice for one?

 

[pvanv]

The dealer i ordered from is going to take it back, apparently i got wrong part, go figure it was only 10 bucks, could you send me an invoice for one?

I sent you a PM requesting your email, etc., by PM.