My motor has no spark after using engine degreaser on it. It is not the kill circuit and it is not the controls. I tested the pulser coil output with a dva and they are all within range, I tested the charge coil and they are within range but there is no test in my manual for the exciter coil. I found something online that said it should be somewhere around 200v on a dva but I'm not getting anything. I'm testing between the two wires in the two pin connector coming from the exciter and get zero when cranking. I checked the resistance and it was somewhere around 175 ohms...is that right? I think it is bad but why would degreaser cause it to fail?
