AGENT 37
Petty Officer 1st Class
- Joined
- Mar 2, 2007
- Messages
- 319
I believe I have a Mercury-badged Tohatsu that I purchased used a couple weeks ago. I'm curious if I can get help identifying what connections need to be jumpered in order to get it to start for a test run on the stand without controls or a tiller before I spend a whole bunch of money getting the tiller with electric start.
Here's the engine info: Model Number: 1A3G312EK / Serial Number: OR568876 manufactured in 2013. The control harness connector on this motor is a 14 pin with female pins mounted on the upper starboard side of the power head, 10 of the pin receptacles are used. Pins and wire colors are:
A- RED
B -BLACK
D- BROWN / WHITE DASH
E- GREEN / WHITE
H- BLUE
J- PINK
K- BROWN / WHITE
L- YELLOW
M- WHITE
N- GREEN
I have a Yamaha /Merc manual that covers four strokes up to 2004 and that wire color coding doesn't match up. But the color coding aligns pretty close to what I see in my Nissan manual that covers two strokes up to 2000.
I have also ordered the Mercury factory service manual for this outboard, I'm just hoping somebody might be able to back me up on where I need to put jumpers to close a run circuit and pull the starter cord on this baby. Everything I checked out good on this motor, I just couldn't do a test run before buying. Thanks for any input!
Here's the engine info: Model Number: 1A3G312EK / Serial Number: OR568876 manufactured in 2013. The control harness connector on this motor is a 14 pin with female pins mounted on the upper starboard side of the power head, 10 of the pin receptacles are used. Pins and wire colors are:
A- RED
B -BLACK
D- BROWN / WHITE DASH
E- GREEN / WHITE
H- BLUE
J- PINK
K- BROWN / WHITE
L- YELLOW
M- WHITE
N- GREEN
I have a Yamaha /Merc manual that covers four strokes up to 2004 and that wire color coding doesn't match up. But the color coding aligns pretty close to what I see in my Nissan manual that covers two strokes up to 2000.
I have also ordered the Mercury factory service manual for this outboard, I'm just hoping somebody might be able to back me up on where I need to put jumpers to close a run circuit and pull the starter cord on this baby. Everything I checked out good on this motor, I just couldn't do a test run before buying. Thanks for any input!