Dave_1984_Bay_Force
Recruit
- Joined
- May 26, 2015
- Messages
- 3
Hi, first post, new. Bought 1984 Bayliner 125 HP Force, compress & spark ok.
Pulled lower unit, replaced impeller, Frank's Step-By-Step.
Then control box handle came off - loose screw, re-tightened.
Now, w handle 'pulled out', handle locked, no move fwd or revrs.
But w handle 'pushed in', handle moves ok?:
Fwd - shft cable moves 1st, shift pivot goes down, throt cable moves 2nd, tower & throt ok.
Rvrs - shft cable moves 1st, shift shift goes up past, throt cable moves 2nd, tower & throt ok.
What done wrong?
thx in adv,
Dave
Pulled lower unit, replaced impeller, Frank's Step-By-Step.
Then control box handle came off - loose screw, re-tightened.
Now, w handle 'pulled out', handle locked, no move fwd or revrs.
But w handle 'pushed in', handle moves ok?:
Fwd - shft cable moves 1st, shift pivot goes down, throt cable moves 2nd, tower & throt ok.
Rvrs - shft cable moves 1st, shift shift goes up past, throt cable moves 2nd, tower & throt ok.
What done wrong?
thx in adv,
Dave