hi and how are you? please I need help urgently.
I have a 1995 bayliner boat with a force 120hp engine.
the engine I had on it when I bought the boat, seize on me and crank stop turning. I was advised to rebuild it or buy another . I went online and found a 1997 power head force 120hp..
I took the seized engine out and dropped in the engine I bought from online. tried to start it, the engine turns just fine, good compression but not starting. it has good gas. Why is gas spilling out from the carb when they those black cover at the back of carb. tiny splash coming out.
I am using all the electrical/ignition components and setup from the old engine on this engine.
do I need to replace the stator, trigger to a 1997 force or the one from the old motor should work fine. the old motor trigger, stator and rectifier are new.
the flywheel from the old engine did not fit on the engine I bought online. the crank on the new engine is bigger so I had to buy a flywheel that fit on the engine.
why am I not getting good spark. with a tester some cylinder has tiny bit of sparks.
next problem, I cannot set the lower unit gears. when I move the gear and throttle control from the driver seat it moves forward and backward but the lower unit is not changing gears or go into neutral. I took lower unit out to replace impeller and put it back on.
help please
I have a 1995 bayliner boat with a force 120hp engine.
the engine I had on it when I bought the boat, seize on me and crank stop turning. I was advised to rebuild it or buy another . I went online and found a 1997 power head force 120hp..
I took the seized engine out and dropped in the engine I bought from online. tried to start it, the engine turns just fine, good compression but not starting. it has good gas. Why is gas spilling out from the carb when they those black cover at the back of carb. tiny splash coming out.
I am using all the electrical/ignition components and setup from the old engine on this engine.
do I need to replace the stator, trigger to a 1997 force or the one from the old motor should work fine. the old motor trigger, stator and rectifier are new.
the flywheel from the old engine did not fit on the engine I bought online. the crank on the new engine is bigger so I had to buy a flywheel that fit on the engine.
why am I not getting good spark. with a tester some cylinder has tiny bit of sparks.
next problem, I cannot set the lower unit gears. when I move the gear and throttle control from the driver seat it moves forward and backward but the lower unit is not changing gears or go into neutral. I took lower unit out to replace impeller and put it back on.
help please