Well long story short, after 23 years of faithful service I need to rebuild my powerhead, I'm waiting on my FSM, but in the meantime I went ahead and torn it down. I've never rebuilt a motor before but have always wanted to have the experience. I have 20 yrs experience in fixing about anything, computers, appliances, electronics, etc.... I have a few questions:
I have unbolted everything I can see and I am still unable to remove the motor, any suggestions???
Any recommendations for piston brands and sources for parts? I've been reading some on wiseco but I let other use this boat at times and I'm a little concerned that they wouldn't allow the engine to warm up before going WOT...
Any other bits of advice from someone experienced in performing this project? I thought I would go ahead and rebuild the fuel pump and possible the carb and all the rubber hoses while I have it apart.
Thanks
chris
I have unbolted everything I can see and I am still unable to remove the motor, any suggestions???
Any recommendations for piston brands and sources for parts? I've been reading some on wiseco but I let other use this boat at times and I'm a little concerned that they wouldn't allow the engine to warm up before going WOT...
Any other bits of advice from someone experienced in performing this project? I thought I would go ahead and rebuild the fuel pump and possible the carb and all the rubber hoses while I have it apart.
Thanks
chris