Was out on the lake running the boat this morning, made my first run and when I started to let off the gas to come off plane, it felt like something with the hot foot broke and the motor shut down before I came off plane. Started looking around, eventually pulled off the cowl and found that the little plastic piece on my trigger arm that connects to the trigger, under the stator and flywheel had broken. Got home, pulled off the fly wheel and found that one of the magnets had broken and part of it came unglued. (The magnet is broken into two pieces. One piece had come unglued and was stuck to the stator when I pulled the flywheel off) One of the other magnets has a small crack and another has a very tiny piece of it chiped off. My question is, would any of you suggest trying to repair that broken magnet and carefully trying to bond it back to the flywheel in it's exact position as it should be with a good epoxy (JB weld?) before throwing the money at another flywheel?