1994 force 120 which holes do the hydraulic lines go into tilt motor 2 wire???

[dirtyrice23]

Me again, I'm pretty sure I put them back in but it seems to b acting funny. I may have switched a hose. Ok the bottom of my motor has 4 hose with 2 of those holes in the middle. From the back to the front, top trim hose in first hole, middle left is bottom of tilt. Middle right is top of tilt. Last hole towards the front of the boat is bottom of trim hose. I may have switched the top hoses from the tilt and trim. Hope I explained that ok. I can't find a diagram and the pic I took for my reference before I took the motor off isn't that great. Thanks guys!

 

[RRitt]

Re: 1994 force 120 which holes do the hydraulic lines go into tilt motor 2 wire???

doesn't help without picture. at least two different models possible for that year. if all else fails, get a bucket and a hand full of 3/16" brake tubing plugs. plug up all ports but one and run pump repat for other holes until all are identified as up or down.

 

[emoney]

Re: 1994 force 120 which holes do the hydraulic lines go into tilt motor 2 wire???

If Mr. Ritt ain't seeing it, odds are nobody else will, he's "da man". Pictures are worth a 1,000 words don't forget. Good luck.

 

[dirtyrice23]

Re: 1994 force 120 which holes do the hydraulic lines go into tilt motor 2 wire???

Here are the pics... How do i prime the cylinders? Do i just keep adding oil and run the tilt trim up and down??? Thanks again guys!

 

[dirtyrice23]

Re: 1994 force 120 which holes do the hydraulic lines go into tilt motor 2 wire???

Do those pics help?