1986 Force 125 Tilt assembly

[CaptinBushy]

Well back again... Keeps getting better and better thought all I was going to need to do was replace the pump and I'd be good to go, but upon further inspection I realized it wasn't the case. I'm very new to working on boats so I have no idea what different parts are. I believe it's the tilt arm that's broken but I'm not positive. I'm not sure if it's easily replaceable and about how much I'm looking at for a price. Additionally not sure how difficult it is to find the hydraulic cylinder lines because it seems that one of them is missing and there is only a spot for 2 of them. Really hoping it's not going to cost me more than what I purchased the boat for. Thank you for your help. The site won't allow me to upload pictures either.

 

[CaptinBushy]

Pictures

 

[jerryjerry05]

The tilt cylinder is missing??
​There are 4 lines, the last pic, that's the trim part of the trim/ tilt system.
There are 2 lines into that part.
​One you can see the other is under the part and can't be seen until the motors off the boat.

​The parts are out there you just need to have $$$

Post a pic of the pump and the holes for the lines.