Hey looking for any kind of help. Have a formula PC with twin Volvo d6 Engines with an electronic vessel control system. Gettin two fault codes saying mismatched chassis numbers with sus/scu and chassis number mismatched with pcu. I just replaced a steering actuator servo and am getting these codes. The boat was in limp mode when steering actuator was bad and currently has no limitations and is operating fine. I do not have any diagnostic software and was wondering if anyone has experienced these codes. It says to preform auto configuration which I found the steps in the manual, did not do anything. Also says reprogram evc system with chassis number. in the settings I can get to the chassis numbers but cannot modify or edit anything from the basic evc screen any help would be appreciative. I have never worked with anything this technical and this setup is very electronical.
