• If this is your first visit to the iboats.com Boating Forums, be sure to check out the FAQ. To post a question or comment, begin by signing up. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement

Announcement Module
Collapse

We're excited to announce the launch of our NEW Fiberglass & Epoxy Boat Repair & Building section on iboats.com! See more details!

This new area was created specifically to meet the needs of those of you who participate in the iboats Boat Restoration, Building, and Hull Repair forum. To kick off the launch, we are giving away free product in every order over $100 as follows:

Spend $100-149: Get a free paint suit (Large only)
Spend $150-199: Get a free sandpaper finish pack & paint suit (Large only)
Spend $200-249: Get a free catalyst dispenser
Spend $250-299: Get a free Sufasolve hand wipes
Spend $300-349: Get a free Aqua Blue buffing compound (quart)
Spend $350-399: Get a free small tint kit
Spend $400+: Get a free Preval sprayer

To qualify for the free products, select any Fiberlay, Spectrum Fiberglass, System Three, or Gibco product.

Also, we have discounted our already low prices by another 5-15%. Stay tuned as we will be giving away 3 $100 iboats gift certificates from May to June to be used on the new fiberglass and epoxy products.

To view the new Fiberglass & Epoxy Boat Repair & Building, go to http://www.iboats.com/Boat-Paint-Repair-Maintenance-Gel-Coat-Cleaners-Carpet-Epoxy/dm/view_id.11
See more
See less

Minn Kota 55 pd stalls with beep code.

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts


  • Minn Kota 55 pd stalls with beep code.

    I have a Minn Kota 55pd with auto pilot and co pilot and I have had nothing but trouble. Right now my major problem is it will run at 1/2 speed OK but if I run it at full it cuts out. I don't think my circuit breaker is doing it, I watched it and the button is not coming out, there seems to be some internal protection I am experiencing. I have read the threads which talk about putting in a #6 rather than a #10 wire but I have #6 already. I checked all of my connectors and all seems OK. Any advise?


  • #2
    Re: Minn Kota 55 pd stalls with beep code.

    How long is the run of #6 to the battery, Mike? If you are running 10-12' or more you might want to go to #4.What does your manual say about the trouble code you are getting?
    sigpic

    Comment

    Working...
    X