J Kent
Recruit
- Joined
- Jul 15, 2012
- Messages
- 3
Newbie here.
I have a Minn Kota Endura 55. Recently the motor stopped working intermittently. After some troubleshooting I replaced the switch. That did not fix it. I found it works when out of the water but not when put in the water. I now suspect a bad seal and water getting into the motor housing. Does this sound right> If so, where can I find instructions on taking the housing apart? What should I look for once inside?
Thanks!
I have a Minn Kota Endura 55. Recently the motor stopped working intermittently. After some troubleshooting I replaced the switch. That did not fix it. I found it works when out of the water but not when put in the water. I now suspect a bad seal and water getting into the motor housing. Does this sound right> If so, where can I find instructions on taking the housing apart? What should I look for once inside?
Thanks!