New member here and have an issue with the power tilt and trim.
I've got a 1976 Evinrude 135hp with the twin ram power trim and tilt. It is wired into a single solenoid and then to the remote switch.
My issue is that when wired as shown per other diagrams I viewed on the forum it will only go up or down depending how I hook up the blue or green wire from the tilt motor. Can't seem to get it to go both up and down. Any help would be greatly appreciated.
Thank you
I've got a 1976 Evinrude 135hp with the twin ram power trim and tilt. It is wired into a single solenoid and then to the remote switch.
My issue is that when wired as shown per other diagrams I viewed on the forum it will only go up or down depending how I hook up the blue or green wire from the tilt motor. Can't seem to get it to go both up and down. Any help would be greatly appreciated.
Thank you