I have done some searching amongst the topics and am not finding a subject already here for this. I am looking to learn the proper way (if I don't know already) to replace the wooden rub rail on my 12 foot aluminum boat. This boat is stripped, it has a hood that bolts to the top front with a dash that holds the steering wheel, controls,etc and a windshield. I know how I would do this but I am wanting to make sure I am on the right path.
I would cut thin strips of wood and place them on the gunwale with clamps about every four inches gluing each strip one at a time using gorilla glue. Once thickness (not sure what thickness it should be) is achieved I would then use sanding/shaping tools to shape the rub rail how I think it should be then seal it with a good marine sealer.
Thank you for your assistance and time. I can provide pictures if needed. I have had the boat for about 5 years now wanting to make a project out of it, but an illness has set me back on all of my projects.
I would cut thin strips of wood and place them on the gunwale with clamps about every four inches gluing each strip one at a time using gorilla glue. Once thickness (not sure what thickness it should be) is achieved I would then use sanding/shaping tools to shape the rub rail how I think it should be then seal it with a good marine sealer.
Thank you for your assistance and time. I can provide pictures if needed. I have had the boat for about 5 years now wanting to make a project out of it, but an illness has set me back on all of my projects.
Last edited: