• If this is your first visit to the iboats.com Boating Forums, be sure to check out the FAQ. To post a question or comment, begin by signing up. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement

Announcement Module
Collapse

We're excited to announce the launch of our NEW Fiberglass & Epoxy Boat Repair & Building section on iboats.com! See more details!

This new area was created specifically to meet the needs of those of you who participate in the iboats Boat Restoration, Building, and Hull Repair forum. To kick off the launch, we are giving away free product in every order over $100 as follows:

Spend $100-149: Get a free paint suit (Large only)
Spend $150-199: Get a free sandpaper finish pack & paint suit (Large only)
Spend $200-249: Get a free catalyst dispenser
Spend $250-299: Get a free Sufasolve hand wipes
Spend $300-349: Get a free Aqua Blue buffing compound (quart)
Spend $350-399: Get a free small tint kit
Spend $400+: Get a free Preval sprayer

To qualify for the free products, select any Fiberlay, Spectrum Fiberglass, System Three, or Gibco product.

Also, we have discounted our already low prices by another 5-15%. Stay tuned as we will be giving away 3 $100 iboats gift certificates from May to June to be used on the new fiberglass and epoxy products.

To view the new Fiberglass & Epoxy Boat Repair & Building, go to http://www.iboats.com/Boat-Paint-Repair-Maintenance-Gel-Coat-Cleaners-Carpet-Epoxy/dm/view_id.11
See more
See less

substitute for fir plywood?

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts


  • substitute for fir plywood?

    Ok, I've looked and looked. I just can not find any douglas fir or marine grade plywood locally. What else could I use for transom and stringers? I will be using polyester if that matters.


  • #2
    Re: substitute for fir plywood?

    Here's Aruco plywood at the Lake Charles Home Depot:

    Arauco 32 sq. ft. Pine Cabinet Panel-781850 at The Home Depot

    It's made with the phenolic formaldehyde (epoxy) exterior grade resin. Good straight stuff with very few if any voids.
    I consider overkill a job well done... plus a little extra.

    There's as many ways to do something as there is people to tell you how to do it... but not all of them are the right way.

    The drinking and debauchery will continue until morale improves... and maybe for a little while after.

    Comment


    Working...
    X