Please note this thread has been inactive for 90 days. For the best results, please start a new thread.
Results 1 to 3 of 3
  1. #1

    Default Outboard 120hp force replacing trim motor

    I have a 1992 Bayliner Capri with a 120hp Force outboard motor. I recently had to replace the trim motor after the old one went out, but I still cannot get the motor to move up or down. Right now it is stuck in the up position; the trim motor sounds like it is working fine only its not moving the motor. Any suggestions on what the problem could be?

  2. #2
    Captain
    Join Date
    Oct 2007
    Location
    Eastern Washington State
    Posts
    3,066

    Default Re: Outboard 120hp force replacing trim motor

    Most likely the hydraulic Tilt/Trim pump assy. that the motor operates is bad.

  3. #3
    Captain
    Join Date
    Mar 2006
    Location
    Cape Coral, FL
    Posts
    3,320

    Default Re: Outboard 120hp force replacing trim motor

    make sure the little hex drive shaft is installed inside of reservoir between motor and pump

Similar Threads

  1. replacing trim cylinder on 76 120HP Mercruier
    By ruggles in forum Mercruiser I/O & Inboard Engines & Outdrives
    Replies: 1
    Last Post: March 31st, 2010, 04:16 PM
  2. 1995 120hp Force outboard will not start or trim
    By estes in forum Force & Chrysler Outboards
    Replies: 1
    Last Post: August 12th, 2009, 06:14 AM
  3. Force Outboard Motor Tilt/Trim
    By dcromer in forum Force & Chrysler Outboards
    Replies: 2
    Last Post: February 13th, 2003, 03:19 PM
  4. 120hp Force Trim/Tilt motor
    By Darren in forum Force & Chrysler Outboards
    Replies: 3
    Last Post: January 17th, 2003, 12:44 PM
  5. 120HP Force Outboard Motor
    By rettus in forum Boat Topics and Questions (not engine topics)
    Replies: 3
    Last Post: April 6th, 2001, 04:50 PM
  1. iboats Forum Directory - Over 100,000 forum posts organized by topic